Your
Qualwood Hidden Rug Hanger is designed to securely hold and display rugs or
other fabrics. The hanger back is
attached to the wall with screws. The
hanger front is attached to your fabric with Velcro®.
The two parts of the hanger are then held in place by gravity.
Installing
the Screws in the Wall:
1. First locate and install the screws
that will hold the hanger to the wall.
The hanger has keyhole slots on the back that will hang on the heads of
screws.
2. The type of screws used will depend
on the wall material and construction. Select
screws which can be securely installed in the wall and which have a head that
fits into the keyhole slots.
3. At each keyhole slot a small hole is
drilled completely through the back piece of the hanger.
Hold the back against the wall. Be
sure it is at the proper height and is level.
Now push the enclosed small nail through each of the small holes to mark
the wall location of each screw. Install
a screw at each mark.
4.
Install the hanger back on the
screws.
Attaching
the Qualwood Hanger to Your Wall Hanging:
If
your wall hanging is made from a fabric that sticks to Velcro (like most
Southwest style wool rugs):
Place your wall hanging on a flat
surface with the back side up.
Press the Velcro strip of the hanger against the top edge of your wall
hanging. The Velcro will stick to the wool.
Now just place the hanger front on
top of the hanger back as illustrated.
If your fabric does not stick to Velcro you
must attach a strip of Velcro loop or felt to the back on the wall hanging:
You
should attach a 1½-inch
wide strip of Velcro loop or felt to the top back edge of your wall hanging. It
is usually sewed on but sometimes can be attached with
pins or a fabric adhesive.
Place your wall hanging on a flat
surface with the back side up.
Press the Velcro strip of the hanger against the
Velcro loop or felt strip on your wall hanging.
Now just place the hanger front on
top of the hanger back as illustrated.
